Posts made by clondyke555

@dc42 not as yet, I've just wanted to test motors so far which with some help I've confirmed are now working I've been on the link and as my machine isnt listed I assume I need to do a custom calibration "my machine is an ooznest" is it pretty straight forward?

@bearer that's it, rookie mistake thank you. So the test initiated all motors, obviously now I have the issue of them going past there limits, so I take it that the calibration is next, or something else? I've had a quick look at the calibration and I think I'll need to do a custom one, is there any good links, videos etc you could point me to so I know what I'm doing thanks again you're a credit to this forum.

@bearer right I'll try that now, thank you as I said I am a newbie so trying to work through as I go

@bearer I got this 2nd hand hand unfinished project, the cnc was already built and with the motors attached, the stickers on all the motors had faded all I could make out was nema. The plugs that came with the motors had 4 wires "red, blue, yellow, green" and were very short so needed to be extended because there wasn't any information on the motor and I couldn't get a data sheet I tested the motor to work out the pairs by holding 2 of the wires and spinning the motor I did this until I got resistance I got this on the yellow and red then the blue and green.

This is how I wired up to the board Green 2B
Red 2A
Yellow 1A
Blue 1B.

Config wise, I have gone much past here, as I wanted to atleast get the initial test motors to work before I push forward with anything else.

Thank you

Hi, newbie here yesterday I finished setting up my cnc, controlled by duet3d. When I've gone in to test motors, the short ground appears as it goes through the sequence of testing each of the 4 motors, but if I disconnect them from the duet3d board it goes through without the warning. As this is my initial testing, I'm not sure if it's something I have or haven't done. I've triple checked the wires, remade the ends at the board and at the motor, but I still have the same issue, motor clicks hums but nothing else. From search through the web theres alot more involved than I initially thought, I am a first time user so please be gentle any help would be amazing thank you.