@CJ-BRAVO @Danal

ok it seems that M108 did screw up the tool change... very weird.

I took it off and tool change works.

thanks!

Hi
can I run 3 stepper motors with external drivers and 2 servo motors with external drivers on the same expansion breakout board from a duet 2?

I understand duet 3 can't run servo motor yet, so duet 2...

thanks

cool!
looks like what i'm after

cheers

Hi there,
looking for a gcode command that allows me to pause a print until a key is pressed (or endstop is triggered).

for example, when layer is done, goto center bed and wait until the key is pressed.
key can be also resume on the DWC or external endstop/key.

thoughts?

howdy
so when do you think we can get one for testing :))

any updates regarding duet3 - servo motor control?

@dc42 you mentioned a prototype back in May, any news?

thanks

@moo16

80% of rated current.

could that be an issue?

Hey,
I get once and a while a strange phenomenon where the direction of my stepper motor changes direction.

I've got M569 S0 or S1 in my config file but sometimes it changes the direction without any warning...

And this happens without changing anything else.

could this be some wiring issue? power thing?

any thoughts?

thanks

ok will give it a shot

thanks

@bearer

I think it is gremlins and I think they had a late supper.

I got it to work I think. changed the SD card.

could it be just the cards' fault? is there procedure of formatting the card?

ok I did M21 to restart the sd card.. i have connection and managed to update the firmware.