Topics created by Christophe

@snimax said in Magnetic Filament Monitor skips values:

@christophe There is a bugfix in the 3.4 release candidate that fixes possible race conditions and that short extruder moves are sometimes missed by filament sensors. If possible you could try it out and see if it solves your problems 🙂

@Snimax With the new firmware Duet 3 Mini 5+ 3.4.0rc1 (2022-02-09) it lasted a lot longer (about 150m of filament) but then the min went down to 9%, and again shortly after that with a second test.

The polling is every 500ms, so the logs seems to be right. But it changes from 2991 to 3006. Which is a difference of 15mm instead of the defined 5mm

2022-02-23 15:24:02.832525 Rev: 25.9 Min% 97 Max% 104 Dist 2986.5 2022-02-23 15:24:03.345354 Rev: 25.9 Min% 97 Max% 104 Dist 2991.5 2022-02-23 15:24:03.869892 Rev: 25.9 Min% 97 Max% 104 Dist 2991.5 2022-02-23 15:24:04.388842 Rev: 25.9 Min% 97 Max% 104 Dist 2991.5 2022-02-23 15:24:04.904781 Rev: 25.9 Min% 97 Max% 104 Dist 2991.5 2022-02-23 15:24:05.422710 Rev: 25.9 Min% 97 Max% 104 Dist 2991.5 2022-02-23 15:24:05.938432 Rev: 25.9 Min% 97 Max% 104 Dist 2991.5 2022-02-23 15:24:06.460237 Rev: 25.9 Min% 97 Max% 104 Dist 2991.5 2022-02-23 15:24:06.982769 Rev: 25.9 Min% 97 Max% 104 Dist 2991.5 2022-02-23 15:24:07.500814 Rev: 26.1 Min% 9 Max% 105 Dist 3006.5 <-- error occurs 2022-02-23 15:24:08.016133 Rev: 26.1 Min% 9 Max% 105 Dist 3006.5 2022-02-23 15:24:08.532569 Rev: 26.1 Min% 9 Max% 105 Dist 3006.5 2022-02-23 15:24:09.047566 Rev: 26.1 Min% 9 Max% 105 Dist 3006.5 2022-02-23 15:24:09.568569 Rev: 26.1 Min% 9 Max% 105 Dist 3006.5 2022-02-23 15:24:10.084863 Rev: 26.1 Min% 9 Max% 105 Dist 3006.5 2022-02-23 15:24:10.602402 Rev: 26.1 Min% 9 Max% 105 Dist 3006.5 2022-02-23 15:24:11.124012 Rev: 26.1 Min% 9 Max% 105 Dist 3011.7 2022-02-23 15:24:11.641503 Rev: 26.1 Min% 9 Max% 105 Dist 3011.7