Topics created by Charlie

@droftarts Thank you!

@Charlie the 2504s are a good pick and they like to be driven at spec.

@jay_s_uk Thank you so much for your help! I must've missed this.

After a long hiatus, Ive come back to the project and it definitely was a wiring issue. The silicone ribbon cable jacket was completely intact, but the wire inside was frayed. Hopefully with a Toolboard installed, I should have less wiring issues. Thank you again to everyone for your help in troubleshooting!

@dc42 thank you!

@Charlie said in Z Home (Error: Failed to enable endstops.):

Im assuming that the rest of the M558 parameters will be followed based on the config file, right? Things such as "Dive height" would be how much Z will lift after probing I presume.

Yes that's right. You can modify individual parameters without specifying all of the parameters.

@CCS86 Yes, Cura 4.6.1 does appear to fix the issue (at least it looks fixed in "GCode Analyzer"). Much appreciated!

Okay, understood. Thank you all for your help!