Hi
I installed a Bl-touch clone and something wired happening.
All seems to be fine when running the deploy, retract and self test macros.
however when i home Z-axis or doing a mesh bed compensation - something wired happens:
1 The probe goes to the requested coordinates
2 deploy the pin
3 the bed goes up toward the bl-touch sensor.
4 after the pin tuoch the bed its auto retract.
5 the bed starts going down
until now all is just fine..
After it probed the point - while the bed goes down away from
the probe - the pin suddenly deployed again, hits the bed very fast and retracts.
this can happen randomly, about 20% of the probed points and
it effecting the bed mesh as red area that appears on the mesh map.
All suggestions are welcomed 
p.s i am running the latest duetwifi 2 fw on corexy printer