Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
@bramerrf Many thanks. That did it.
@stephen6309 said in New issue after upgrading firmware to 3.4.1:
M591 D0 S0 ; turn off filament monitor
Thanks for all the replies. I will try to put everything I want into stop.g and see how few mistakes I make. Thanks again.
@phaedrux Granpa Pig solution worked. Disconnect printer, shut down completely, have a cup of coffee, turn power back on, restart printer. Z probe now working correctly. Printing a test job right now. Thanks again.
