Posts made by BorisM

I thank you very much for your suggestions hints! Tweaking the mechanik to have a clean functional built is one thing I would like to achieve and getting the ounce out of precision I ll do the firmware tweak which John pointed out!
Thanks a Lot for your help @all!
Bye
Boris

okay, thats interesting. Indeed the X-Belt is not as exact the same as y and z but far away from sluggish or whatever. I´ll tighten that one. Play is not there as seen by the eye on every joint. A gauge will find some for sure. Good points with the rods. I will check that.
I thought that there is a compensation available somewhere in the firmware. I could compensate that while constructing parts, too. But knowing that there is something wrong would drive me nuts…
Thanks!
Boris

Hi!
I started tuning my new (first) delta with the duet wifi. By the way I am amazed by this board using 0.9 deg/step motors the fan of the E3D @24V is the loudest noise when printing!
Ok now the problem: I have printed several objects like a 20x20mm square etc. and I constantly get 20.25mm instead of 20 in X direction. Y is fine, Z, too.
Autocalibration ends always around 0,064.
Is there a solution for tuning this in the firmware? I guess it is a problem coming from the mechanics?
Would be happy about some help.

Bye, Boris