Best posts made by bilsch

@fcwilt said in 4 independent z axis tilt:

M671

Ok yea I think I'm getting this now thanks! I also found https://www.mrappz.com/voron-electronics-setup-i/ - going to let this churn a bit and see where it goes thanks!

Bill

Ok, issue solved wow!

So I probably missed it but getting the Duet2and3Firmware-3.3.zip and uploading it via the web interface put the firmware files in place. Once I followed the other forum article and got that hooked up - its working just fine! ( well, 3hc is still need to hit the 1lc )

Ok at this point with the information in the thread - its working now. I just used the values from the referenced config but I spot checked it on my bot - within 1mm so I just stuck with that

I consider this resolved thanks @fcwilt !

@fcwilt Ok confirmed yea this is exactly what I needed thanks!

@jay_s_uk Awesome thanks so much!