Hi all, has anyone else had issues with their IR z probe not triggering at 500 as per the documentation at this link? mine seems to trigger right at 420. Right before the light comes on the number is 408 and right after the light comes on, the number is 439. Is this an issue? Will I see accuracy issues because of this? After i set the trigger value to 420 in the firm ware, it seems to work, but I seem to be having to micro step up or down with each print to get it to stick. I'm using mesh grid compensation.

I'm wondering if the minor variations in z height are because of the probe not having a repeatable trigger offset. Bed surface is blue tape over a MIC 6 aluminum bed. Thanks for your suggestions.

Ben

Update- Web control did indeed come up this time after I reset the IP address. Not sure why it didn’t work before. I will continue working through the quick start guide by editing the config.g file. I haven’t had a chance to mess with this as I had to run out the door right after the web control came up.

I did indeed buy the Duet Ethernet. It is not a conversion. I found a micro sd card reader. I forgot that I had one. The /www folder looks to be in order. I have attached screenshots of the files. I also sent the M122 command, and have attached the screenshot. It seems that the SD card is working fine based on the M122 command. However, when I first started up the board, it went to run config.g and threw and "daemon length overflow" error. Could that be causing the issue?

Great. I’ll look into this tomorrow. I need to go buy an adapter so that I can get the micro sd to load into the sd card slot on my laptop. Theres not a better way to access the files, right? It can’t be done through usb, with the card still in the board, right?

Here's a bit more information from using the M111 commands mentioned earlier in the thread.

Ok. Great. After entering those commands, It did send back a new IP address. I can now ping that IP address. However, when I enter that IP into the web browser, a blank screen is all I see (chrome). It does seem to reach that address, but there is not web control there. http://duettest.local/ does not work either.

Thanks for the quick reply. Removing these commands from the config.g file would need to be done by plugging the SD card in and modifying the config.g file in notepad, right?

@dc42 just got my Duet Ethernet out of the box and I am having the same issue as RetiredinNC. I have been following the guide here. Please see attached screenshots from YAT and the command line. When I send the M552 S1 command after an M552 command, nothing happens (I waited for a few minutes after sending that command) When I send a M552 S0 command, followed by an M552 S1 command, it indicates that the network is running, but I cannot ping the device and cannot reach the web interface by typing the IP address into the my web browser. I know next to nothing about networking and am out of ideas. Thanks for your help.