Posts made by bay3d

@jamesm could you send me your stepper settings From your config file? Maybe I have something setup wrong.

@dc42 duet wifi, the most recent one

I've been playing around with the T0FF settings to try and make my motors silent while idle like the wiki suggests however they are still noisy at every level when idle. Since the ender 3 is a fairly common printer I was wondering if anyone else had found a solution to this?

@jamesm do you know which wire is which when compared to the original connectors? If not how would I figure it out

Hi, I'm sure this is a dumb question but I can't figure out how to wire the stock ender 3 endstops to the duet wifi, the guide says for endstops with two wires (which is what the ender 3 has) to use ground and signal, but when I look at the wires connected to the ender 3 endstops they say signal and voltage.

If anyone has done this before and could explain how they wired it that would be fantastic. I've looked around the internet but I can't seem to find an answer to this.