Hi, thank your for your answer, I will supply complete files when at work and has access to the files. For hte time being, Im running the toolchanger with a Duet Wifi 2 and Duex expansion board, and RRF3.xx firmware.
@jay_s_uk
Where in the documentation can I find more information about this? I find it odd that that since RRF should be "everything g-code" I would expect to find the actual g-code command instructning the printer that leads to this behaviour. If this is not the case, troubleshooting because very hard in my opinion. If this is a desired behaviour, why not put it in the tpre/post/free so users can identify the source of the behaviour? Im sure there are good reasons for not doing this, but Im just asking out of curiosity.
I dont want to apply tool offsets, since im using an automatic tool offset calibration setup as develop by Danal Estes: https://github.com/DanalEstes/TAMV. For me it would be easier if I can start without any offsets applied and let the automatic calibration take care of that.
Anyway, thank your for your input! I´ll supply more information when Im an work.
Best regards
aze