Posts made by Asdfasdf426

@blacksheep99 Also I just checked the Gcode files that cura is putting out are 0 bytes. Do you have any idea why this may be happening and possibly how to fix it?

@blacksheep99 Hi I think I may be having a small problem when I load gcode (from cura) onto a Micro SD card and put it in the printer the printer says no models found. To set up cura I just copied and pasted the start and gcode from your ST3Di_Modelsmart_200.def.json.zip file. Was this the right way to that or have I done it wrong. Or do you know if this may be another Issue.
Additionally, do you know what I should put for the X and Y offsets for the nozzles because I don't really know what they are and how to find them out. (I just measured the distance between the nozzles with a vernier callipers and but that as the X offset Which I'm sure is not the right way, Do you possibly know how to do it and/or have the offsets?) Thanks for all your help so far.

@blacksheep99 I can open the links in this thread to get the google doc, my problem is that when you say save these file in the doc I cant because when I click on them they are images and I don't know what's happening same thing with the Cura profile (the one in the document that you have created I cant open it and when I click on it is treated like an image.) And I am unable to open/save the setup files. I am not sure what the problem is do you have any idea

@blacksheep99 Hi I know I'm a bit late to the thread but I have a ST3Di 280 printer and I am trying to set it up with Cura and to use 3d party filament. But in you word document I am unable to open them and they seem to be formatted as images. do you have another way that I can access these files.