@Arnold although all board front and rear traces and components appear fine

@dc42 Not that i feel. problem now is 24v at vin terminals nut 1.7v at DWC sensor. i fear i may have popped it...

My 5v is gone, plugged in usb and we're back though not ideal

Panels dead, always on fan off. Fuses ok, no signs of burnt out board components.
Any ideas helpful! It's a WiFi ,
Rob

just can't get antenna to seat properly, it must have been pulled roughly. Can I use a workaround for my duet wifi?

@Arnold said in Just cannot resolve motor phase errors and shifting:

After no previous probs I just can't stop the above. Ive continuity on the motor phases, not going too fast, currents are ok. Wiring tests fine. Its always x, shifted to E0 driver, same reports. Can be either phase A or B. Multiple reports repeatedly. Haven't tried a diff motor. Ive had a brain injury so Im not as sharp as I was but this is essentially making my machine useless. Its usually within first few layers. I prefer simplify 3d. I have noticed my Vin can wobble between 10.5 to 12.5 or so. All the posts here haven't helped yet. Any ideas clever ones? Thank you

I was sidetracked and thank everyone for their responses. In the end I dropped the z motor current 200ma and so far so good. Thought id tried it before but hey.

Rob

Thanks all I'll get back to you shortly. Rob

@Arnold Its just shifted x about 30mm as I write....

After no previous probs I just can't stop the above. Ive continuity on the motor phases, not going too fast, currents are ok. Wiring tests fine. Its always x, shifted to E0 driver, same reports. Can be either phase A or B. Multiple reports repeatedly. Haven't tried a diff motor. Ive had a brain injury so Im not as sharp as I was but this is essentially making my machine useless. Its usually within first few layers. I prefer simplify 3d. I have noticed my Vin can wobble between 10.5 to 12.5 or so. All the posts here haven't helped yet. Any ideas clever ones? Thank you