Hello !
I am wondering if there is a feature for Reprap Firmware which counts the total hours of operation and/or total hours of printing? To be clear, the total hours of operation counter would start increasing as soon as there is power to the Duet Board. In a similar manner the total hours of printing counter would increase only while printing.
Regards,
Arek
Hello,
I,ve found that deleting a file in sys folder makes no impact for running a firmware. The lack of file is noticed only in the monent of calling a function. Is it possible to perform a self check of firmware at the beginning of run ? I mean that in case of a lack of file should be clearly noticed right after powering on the electronics.
@deckingman
Duet3d is an awesome electronics. Therefore it is implemented in many professional applications. That's why I've asked for such feature, because in my opinion it's very important in this area.