@jay_s_uk Seems to have fixed it. Through my input shaping graph looks very strange, no big peaks

@droftarts said in Duet 2 WiFi w/ Duet Accel - No Accel Found?:

@APynckel ok, and what version accelerometer? It’s on the PCB.

Ian

says v1.0

@droftarts

Board: Duet 2 WiFi (2WiFi)
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.4.5 (2022-11-30)
Duet WiFi Server Version: 1.27

So I have the Duet accel mounted between my nozzle and heat block as such (Origin is rear right from this picture, x axis switch on right, y axis up front)

I have the supplied ribbon cable connected to the "Temp Daughterboard" header. I assume correctly, otherwise would the LED light up?

My M955 in config.g is
M955 P0 C"spi.cs2+spi.cs1" I60

I have the Input Shaping plugin installed and activated, but when I go to run a "record motion profile", it says "No accelerometer found!"

WHY?

(the 123 block is to offset my Z zero so the board wont crash into the bed when the bl touch tries to home)