Best posts made by andy-vickers

Adding a +1 from me. With the new Voron Extruder the Stealthburner hitting RC1, this design is largely finalized and will be released soon. The Duet 6HC & Toolboard combo makes a very good setup for this printer with the features it has. It also eliminates the need to send 20+ wires through 3 x cable chains to the tool head with the can bus. That, and Thomas Sanladerer built his Voron 2.4 with a Duet meaning his 417K subscribers got to see that build. Almost half a million people viewed his Voron videos using a Duet by the stats. I am sure there are a lot of people buying into the Duet ecosystem for this printer just from these videos alone so perhaps if the full Voron 2.4 isn't supported because of neopixels on the tool board then I think there's a compelling reason to add it to the firmware. @dc42 would you have any thoughts on this?