!!&%!(!&
I was able to infer what the problem was by reading what dc45 wrote about the panel due in other posts.
Turns out someone mucked with my baud rate setting. !%^$!#@&^$
So for those who are having the same problem as i described above...
CHECK YOUR BAUD RATE SETTING It can't be higher then 57600.
and...
Be careful about bringing things to show at meet ups!!!
@rushmere3d The heart of my problem was that I simply edited the S labels to H in all my Homing scripts. Bad idea. I should have simply swapped out the old files for e3d’s new homing files. My old files used the M574 command which reset the end stops incorrectly for the update. I have no idea why the m574 command was in the original homing scripts…
The second problem was because I had not read the ALL of the docs on the pin out labels. As such I had assumed the exclamation mark was on all pinout names. I went back and ready the whole thing and found the ! Sets the polarity of the connections.
Heaters all tuned. Almost ready to print. Again thanks to all for the help.
And… yeah I’ll talk about the update in the 3d Printing Today podcast.
I had the same problem. Turned out it was EMI. or RF noise. I switched from a T/c to a thermistor and the problem never reoccured.
Too bad the mesh compensation turned out to be such a total waste of time. It works better just to tweak the leveling knobs and just chuck the unnecessary complexity.
@andy-cohen The messages were from the homing scripts.
Just printed a perfect cal cube. Thanks for all your help and especially your patience. I'll be sure to do a shout out to you (well... your online handle at least) on the podcast. Without your help (and the others here) I do not think I would have figured it out.
@bot Thanks, I got it. Lets hope the MOFSETS do not blow.
I’m still using v2.X of RRF. I’ve been experimenting with moving from Simplify3d (which has not been updated in years) to Prusaslicer. Trying the paint feature in the latest beta version. Each time I try to print the Duet board reboots during the print. I’ve swapped out the PS and put in a new power switch thinking I had a HW problem, but nowIm wondering if maybe the older version of RRF does not like the gcode coming from the latest Prusaslicer. Is this a good inference?
@phaedrux Yup I blew the 7.5a fuse in the extension board. There has to be a short in the heater cables.
@oliof I see. Thank you. I looked at the Duetlapse docs. It does not do what I need. Octolapse does. It’s an easy trade off.