@blitzreg Run a M303 T0 S300 to calibrate the heater and remember to configure the thermistor

M308 S1 P"e0temp" Y"thermistor" T100000 B4725 C7.060000e-8

@thedragonlord said in Issue with PanelDUE 7" latest firmware:

.resetting the Panel2 as well restarting the printer has no effetcs....this doesn't happen any time but about the 90% of the times....is it a known issue? In ca

That happened to me once, it was the case not the software causing it. Check that there is no pressure on the display.

Use G31 in config.g. Measure the offset of the probe from the nozzle in both X and Y axis and the Z offset to compensate, in my case the probe is 0.7mm lower than the nozzle.

G31 P500 X-4 Y-41 Z0.7 ; Set Z probe trigger value, offset and trigger height