Topics created by alielsayid

i had "single extrusion walls" in S3D and and "fill gaps in shells" enabled in IM . thats why the corners were "complicated".
i'll test again both slicers without those settings tomorrow .

Please post the results of M122 so we can see some hardware and firmware version information.

What version of DWC is installed?

What firmware version is on the Paneldue?

How is the PanelDue connected to the Duet?

RRF V3
Optical sensors like the ones used for endstops.

I will try connecting them to E0 and E1endstops and add the below lines in config.g file.

M591 P2 C"e0stop" S1 D0 ;filament monitor connected to E0 endstop
M591 P2 C"e1stop" S1 D1 ;filament monitor connected to E1 endstop

Thanks

@alielsayid Isn't using four rather than three a recipe for overconstraining, bending, and potential damage?

Thanks for your reply.
I tried connecting to 5v, still same problem, no flashing on start.

Since it's a clone, now I believe it's faulty.
alt text