Topics created by ajlapp

@ajlapp Looks like M42 is the correct direction

Servos
https://www.ebay.com/itm/180W-Brushless-DC-Servo-Motor-Dirve-Kit-6-7A-36VDC-0-57NM-Square-Flange-ACS806/112014849053

Linear Rails
https://www.amazon.com/gp/aw/d/B06VVXT19J?psc=1&ref=ppx_pop_mob_b_asin_title

Ball Screw
https://www.amazon.com/gp/aw/d/B01LXZTNRY?psc=1&ref=ppx_pop_mob_b_asin_title

The frame is thick wall steel square tubing with a pad welded to one face. That face was machined flat with the bearing blocks mounts and other features all in one shot.

I’m using a E3D Volcan with a 1.2mm nozzle and 3mm PLA for now.

We had a project planned for this that has since dried up so for now we’ll just be using it as a general printer.

Ha! Why do I have my M208 set to Z-780??

🤦‍♂️

This would have saved my buns twice now.....I never even saw that.

X and Y are set correctly...go figure.

Been working on this beast sporadically for almost a year...should be printing this week finally. Mind the mess and dangling wires!

IMG_0806.JPG

Working! 24v and the thermistor line in config did the trick.

also you ignored the very big warning for M584 to unmap the old assignment

@ajlapp yes that M584 is indeed a valid approach

I think both of those are workable solutions.

I should be operational sometime next week.

I’ll load some pics once the magic starts.

Thanks again.