Best posts made by adhanabal

@Phaedrux I adjusted bed size in slicer and mentioned tool offset
and created custom bed image to avoid placing the object in wrong position in the bed for tool heads.

Hello all
Mainboard: Duet 3 6HC
Im working on SLS 3d printer project, its almost complete,
I have an issue in X & Y using Nema 17 1.8'motors,
I use stepper motors to move mirrors on X&Y (both mirrors mounted directly on the motor shaft on X & Y)
my working distance is around 195mm from Y-Mirror,
So as per the steps per mm calculation, My steps per mm is 40 @ 256microstepping,
this system not working well, especially when i draw a circle it turns to oval with un even shape, i have attached some sample photos, can anyone give me idea?

hello all
is it possible to keep only xyz axis motors in defined idle current ,
i want to keep extruder motor to become zero idle current,

or is it possible that m571 command i can define for individual extruders for some operations in which i require to allocate different outputs for different extruders,

board; duet3 6hc, firmware 3.3
please help
@dc42

I wanted to avoid unintentional changes to config file, so locked out system folder with password by editing DWC source code. This protection is only for web interface for now. & DWC-3.4.5 only.
Also we remove Install updates button from - Machine specific tab
But -- if someone reads SD card in the PC, they can see config files.
Let me know if we should work on RRF 3.4.5 for locking the sys folder ,

@fcwilt yes from config tool and next time i will upload the files in the mentioned way.

@jay_s_uk yes I ll do that.
Still finding an easy way to edit with users own password.
Will upload things once found.

Hi all
I'm using IR heaters to heat my chamber,
I placed my temperature sensor far from heater to get perfect chamber temperature readings,
Problem is heater going to fault, stating temperature raise is too low, 0.1deg/sec
How can I overcome this issue,
I tried PID tuning but it was taking 2 hours to reach phase 3 (measuring) , and didn't complete the tuning.
Any guidance please