Topics created by 3dTony

@3dTony That explains it. Your end stops are actually active low (NO) and you selected Active High (NC). Or rather Active High is the default which you didn't change. So I'm afraid we can't blame the configuration tool. ☺

Thanks for the replies. I decided to swap the bed for another one that I have. Now it looks much better. I'm not sure what happened, or why that made a difference, but I'll live with it.
No, I hadn't used hairspray or anything on this bed. I just used blue tape and that was it. Nothing different really. It started doing this after the printer wasn't used for about 2 or 3 months. I'll just leave this other bed on it and go on from here.
Thanks again.