@Phaedrux Thank you!

I will give that a go and see what happens,

thanks again

Hi all,

I'm experiencing a weird issue with my 3D printer running Duet 3 - 6HC.
I have had this board for couple of years and its been working fantastically, today during one of my simple prints I notice that the connection to the Web interface, and then after couple of resets it now fails to communicate at all and the PaneDue display "Connecting" and does not progress any further?
I did not change anything etc., the red blinking LED still blinks at the same rate, all the other status LED for voltages are lit also?
any ideas are gratefully appreciated!