Best posts made by 1ri

undefined

via google translator

Awesome !! I have tried the new DWC 2.0.0 RC1 and looks very well done and will allow a lot of evolution. Only one thing. I had to comment on the line that defines the machine's password (M551) in order to access the machine. With the password I was not allowed to enter on Safari (Mac and IOS), Explorer (Windows) Google Chrome (Mac, IOS and Windows).
Thanks for the good work and have a good Christmas

undefined

@c310
i use this commands to declare the "virtual" sensors

M308 S20 Y"mcu-temp" A"CPU" ; Defineix sensor S20 com a temperatura de la CPU
M308 S21 Y"drivers" A"Duet_drv" ; Defineix sensor S21 com a temperatura dels drivers de la duet
M308 S22 Y"drivers-duex" A"Duex_drv" ; Defineix sensor S22 com a temperatura dels drivers de la duex5

In this case, sensors 20 to 22 to declare mcu & drivers.
After that, use it as a standard sensor.

Hope it helps you. I'm runing 3.0RC1 on a DuetWifi + Duex5 and there is no issue at all. A little tricky to configure but not impossible, using Reprap config tool as a start point.

undefined

The printing time appears in “enventlog.txt” if you have it activated whit M929 P"eventlog.txt" S1

undefined

@paboman

This may help you

https://duet3d.dozuki.com/Wiki/Duet_Wiring_Diagrams

See the xpansion pinout. 35 to 39 are what you are looking for, I think

undefined

@wkellyo

Given the ease of programming the WS2812b type RGB LEDs in the arduino environment, here's what I've done:

set an output PIN for use with M42
Connect this output pin to an analog input pin of the arduino. In my case I use an ESP32 which can bé easily purchased.
Monitor the input of the arduino to see what values it gives according to the values set on the M42. Depending on whether it is 8 or 32 bits the sampling may be different
Decide what values I use and why (Warm up, start, print, ....)
Program the Arduino with the FastLED library that will assign a color / effect according to the value of the input PIN
Write a macro in the DUET for each output value of the PIN that connects to the Arduino
Call the Macro in order to provoke the output by the DUET PIN which will be sampled by the Arduino and execute the code to put the LEDS in the color chosen in previous steps.
I have it that way and set different scenarios for Standby, warming, cooling, calibrating, printing and off. I call macros from confit.g at printer startup or from G-code generated by Slic3r. Alternatively I can enable them from the PanelDue.

Hope it helps as Google Translator helps me