Topics created by 0nn0

@0nn0 You can put it in config.g with S1. As it says in the documentation...

1 = enable filament monitoring when printing from SD card,
...
Filament monitors accumulate calibration data (where applicable) even when filament monitoring is disabled.

Ian

I'm planning to make a printer with multiple tools (based on LGX extruders) and equip it with revo nozzles. So I would like to see a setting per tool, much like the filament drop down.

I'm still curious if there is any chance of this happening.

If no official release from Duet is forthcoming, is there anyone in the community who can help me create this? I'm willing to do the design work, but I need guidance on how to proceed, as I have no experience with designing electronics.

@chrishamm Thanks for your help! 🙂

@droftarts I had not considered the possibility that this was a machine parameter. I had only checked out the parameters for the G30 command. Thanks for pointing this out!

@0nn0 the USB connection is just there for setup etc using YAT. its not needed for day to day operation

@dc42 Thanks for the suggestion. I plugged the thermistor back into temp0, and somehow the value was now correct. I'm not sure what caused it to be abnormal before.

I did check M308, just to see if all was okay, and the values are L5 and H6 for both S0 and S1. That does not seems to be very large to me. Maybe I had a bad connection, even though I did press the connector all the way down.

Anyhow, thanks for the support!

@dc42 Thanks for confirming this.

@0nn0 i buy kits of duet connectors directly from Duet3D. Maybe send them a message at sales@duet3d.com

i've ran RRF on a fly-gemini-v1 and that only has 512Mb of ram.
I had to run it without a gui though as 512Mb wasn't enough for a desktop