Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Panel Due 5i USB vs Control Board Power Anomoly

    PanelDue
    3
    3
    300
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • bfpa40undefined
      bfpa40
      last edited by

      When I conncet my Panel Due 5i up via a USB Power and not have the Printer on all seems good. However when I let my Printer (Ender 3 with DUET 2 Maestro) power it the touchscreen goes non-functional, i have restarted the printer numerous time and a couple times the panel responds to touch but for the most part it doesnt. Again if powered by external 5 volt USB Source only all is good. Is there something I can check in order to resolve this issue?

      Stephen6309undefined 1 Reply Last reply Reply Quote 0
      • Stephen6309undefined
        Stephen6309 @bfpa40
        last edited by

        @bfpa40 I recently had my PanelDue become touch unresponsive, but not everywhere on the LCD. I had to reroute the main 4 wire cable to a different position. Looks like there is some interference it doesn't like.

        1 Reply Last reply Reply Quote 0
        • frank26080115undefined
          frank26080115
          last edited by

          try a ferrite bead at the end of the 5V cable? you can buy cheap ones that just clamp on to the cable, super easy.

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA