Cura 3.6 problems
-
@burtoogle I think something like 830 per mm for my titan extruder, but that is not something the slicer cares about.....I have printed fine with Cura slices before and I still print fine with Slic3r. This is not a RRF/Duet problem. It is either a bug in Cura (behaviour of relative extrusion) or I have Cura configured wrong.
The printer works fine, just not with files sliced by Cura 3.6 with 'relative extrusion'enabled. I see M83 in the g-code...but is doing something funky... -
@alexlin, that's understood. Well, I'll take another look at the gcode and see if I can spot what's going wrong.
-
I found the problem, the pause at height script is leaving the extruder in absolute mode.
-
The pause at height plugin appears to unconditionally add an M82 to the end of the script. That's a bug!
-
@burtoogle O sh*t I must have used that once a long time before and it survived the upgrade to 3.6. I will disable it and see whether that works and report it as a bug to Cura/plugin. Thank you very much for your efforts!Greatly appreciated!
-
I have created a Cura issue reporting this bug.
-
@burtoogle thanks!Service!
-
verified that that was the problem...this has worked before but seems to be broken in the plug-in
-
i have a custom delta printer with duet 2 wifi, i usually use slic3r, but when i started using cura on my ender 3, the top surface finish was better. so when i tried using cura with delta the extrusion was at a very very low rate, i have turned on " relative extrusion" on cura.
Should i make any other changes to the cura of duet settings?
-
@alexlin how to disable it?
-
@paul12 disable what?the plug-in...that was something very specific for me since I obviously had turned it on in th elast print in an earlier version. You should be good with th erelative extrusion turned on
