Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Trouble Shooting - not sure where to start

    Scheduled Pinned Locked Moved
    General Discussion
    4
    22
    1.9k
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • TwoToneundefined
      TwoTone @dc42
      last edited by

      @dc42 I'll try. I am using a Yellow Jacket quick clip so it makes it hard to get a good picture at the hotend side.

      I had the single wires from the PT100 going into the bottomside and then the 4 wires from the top.

      I am going to eliminate that and directly wire everything and see if that works. Just guessing at this point is the Thermistor worked before with the connector

      1 Reply Last reply Reply Quote 0
      • TwoToneundefined
        TwoTone
        last edited by

        Figured it out.

        I believe the PT100 wire gauge was too small to make a good contact in the connector.

        It was good enough for resistance reading but not when things were powered up.

        I seperated out the PT100 wires out and used a smaller JST plug and it's all working now.

        Thanks for the patience.

        1 Reply Last reply Reply Quote 2
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA