Speed, Accel and Jerk values
-
Hi all,
I am trying to get my delta to print fast and with good quality (isn't everyone!). I was hoping some of you with working deltas would be able to share the values for your speed, Acceleration, and J**k. Obviously all printers are not created equal but was hoping for some base values that i could start at.Also what should the accel and j**k values be on my titan extruder? Should they just match what I have for the 3 towers?
Thanks,
Chris -
I don't use a titan extruder, so I don't have any idea for that, but for my delta (which has a heavy effector due to direct drive extruder) I use these values as a compromise between speed and quality, leaning heavily towards quality:
Accel: X,Y: 1000 mm/s/s, Z: 200 mm/s/s
J**k (Max instantaneous speed change): X,Y: 480 mm/min, Z: 200 mm/min
Feedrate: 60 mm/s default feedrate, 110 mm/s travel moves, slowing down the feed on the outer perimters to as low as 24 mm/s depending on the model. (smooth curves can go faster, hard corners need slow downs to prevent ringing).For my extruder, I do not use the same accel or j**k settings on the extruder. The accel is 2400 mm/s/s, and the j**k is 120 mm/min. Max E speed of 5 mm/s
-
For delta-printers RRF uses these settings for carets (steppers) or for effector?
-
For the effector.
-
Thanks bot! That helps a lot and will give me a good place to start.