Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Adding on/off switch to paneldue

Locked

Duet Hardware and wiring

1

1

393

Log in to reply

undefined

timcurtis67
last edited by

I want to add an on/off switch to my paneldue so it isn't lit up all the time while printing. Which wire is the best to place the switch in? The positive or the negative? Or should I cut both positive and negative?

I'm not sure if any kind of voltage will back feed through the RX or TX wires so that is why I am asking.
1 Reply Last reply
Reply Quote 0

1 / 1