Completely unreasonable measured per revolution?
-
All of a sudden my sensor seem to have lost its little electronic mind.
A full poweroff does not fix it.
Running 3.5.2
; Filament sensor M591 P3 C"e0_stop" S1 R20:200 L24.8 E6.0 D0
2024-08-06, 15:49:53 M591 D0 Duet3D magnetic filament monitor v3 on pin e0stop, disabled, 24.80mm/rev, allow 20% to 200%, check printing moves every 6.0mm, mag 132 agc 86, measured 11604.83mm/rev, min -188% max 34941% over 3059.9mm 2024-08-06, 15:49:52 M591 D0 Duet3D magnetic filament monitor v3 on pin e0stop, disabled, 24.80mm/rev, allow 20% to 200%, check printing moves every 6.0mm, mag 132 agc 86, measured 11604.83mm/rev, min -188% max 34941% over 3059.9mm 2024-08-06, 15:49:51 M591 D0 Duet3D magnetic filament monitor v3 on pin e0stop, disabled, 24.80mm/rev, allow 20% to 200%, check printing moves every 6.0mm, mag 132 agc 86, measured 11604.83mm/rev, min -188% max 34941% over 3059.9mm 2024-08-06, 15:49:49 M591 D0 Duet3D magnetic filament monitor v3 on pin e0stop, disabled, 24.80mm/rev, allow 20% to 200%, check printing moves every 6.0mm, mag 132 agc 86, measured 11578.66mm/rev, min -188% max 34862% over 3053.0mm 2024-08-06, 15:49:47 M591 D0 Duet3D magnetic filament monitor v3 on pin e0stop, disabled, 24.80mm/rev, allow 20% to 200%, check printing moves every 6.0mm, mag 132 agc 86, measured 11578.66mm/rev, min -188% max 34862% over 3053.0mm 2024-08-06, 15:49:32 M591 D0 Duet3D magnetic filament monitor v3 on pin e0stop, disabled, 24.80mm/rev, allow 20% to 200%, check printing moves every 6.0mm, mag 132 agc 86, measured 11529.47mm/rev, min -187% max 34714% over 3040.0mm
-
It seem to be a TPU thing. WHen loading Ninjaflex, it seem to just not grip the filament enough, leading to these unreasonable values.
Well, I guess I can live with that..
-
Hm.. I suppose that IF the magnet rotated verrrrrry slowly due to being obstructed or similar, this could happen... I suppose a teardown is in order.
-
-
It seem to be a TPU thing. WHen loading Ninjaflex, it seem to just not grip the filament enough, leading to these unreasonable values.
Well, I guess I can live with that..
-