Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    M122 and no output after a spontaneous shutdown

    Scheduled Pinned Locked Moved
    General Discussion
    1
    2
    60
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Trietundefined
      Triet
      last edited by Triet

      I had a job running longer than a day and the printer suddenly decided to shut down.
      After restarting it, when I issue the M122 command, I get no diagnosing information. The printer itselfs behaves OK (...well, until it perhaps shuts down again during a long job). Running RRF 3.4.6.

      What might be wrong with my Duet2 WiFi?

      Trietundefined 1 Reply Last reply Reply Quote 0
      • Trietundefined
        Triet @Triet
        last edited by

        @Triet Sorry, ignore my question.
        While trying to get any output I tested M291 P"Test" and it worked as expected.
        Afterwards, M122 is also showing diagnose information. Do not know what was happening here.

        Please roll back my question.

        1 Reply Last reply Reply Quote 0
        • Phaedruxundefined Phaedrux locked this topic
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA