Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    M569 step pulse width

    Scheduled Pinned Locked Moved
    Gcode meta commands
    2
    4
    127
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Doshsundefined
      Doshs
      last edited by

      Hello guys, Is it possible for each driver to set its own parameter T in the M569 command? Or will only the larger value of the T parameter be used for all drivers?

      Board: fly_F407ZG (stm32f4-wifi)
      Firmware: RepRapFirmware for STM32F4 based Boards 3.4.6_101
      Duet WiFi Server Version: 1.25-01S-D
      Duet Web Control 3.4.6

      nikschaundefined 1 Reply Last reply Reply Quote 0
      • nikschaundefined
        nikscha @Doshs
        last edited by

        @Doshs

        Here in the notes it says:
        "RepRapFirmware takes the highest T parameters seen in any M569 command, and applies those values to all drivers for which any nonzero T parameter was specified."

        Stay in school

        Doshsundefined 1 Reply Last reply Reply Quote 0
        • Doshsundefined
          Doshs @nikscha
          last edited by

          @nikscha I was hoping that this is not true and there is a way to change the parameters 😁

          nikschaundefined 1 Reply Last reply Reply Quote 0
          • nikschaundefined
            nikscha @Doshs
            last edited by

            @Doshs hahaha hope dies last I guess ^^

            Stay in school

            1 Reply Last reply Reply Quote 1
            • First post
              Last post
            Unless otherwise noted, all forum content is licensed under CC-BY-SA