PT1000 Low temperature Reading
-
Anyone know why my temp sensors would read such a low number? In ambiet room - bed temp is true. Pt1000 hotend temp claims 7.5 degrees. These are slice engineering PT1000 sensors. Firmware:
M308 S1 P"temp1" Y"PT1000" A"RTemp" ;Pt1000 located in right side of hot block
M308 S2 P"temp2" Y"PT1000" A"LTemp" ;Pt1000 located in left side of hot block
M950 H1 C"out1+out2" T1 ;2 Heaters wired to separate connectors but treated as a single logical heater
M570 H1 S360 ;Hot end may be a little slow to heat up so allow it 180 seconds
M143 H1 S310 P1 T1 A0 ;Monitor heaters with sensor 1
M143 H1 S310 P1 T2 A0 ;Monitor heaters with sensor 2Doesnt seem to matter if i switch them... I've tried everything under my small umbrella of knowledge. Vref, Voltage to sensors. I see talk of resistance stuff but i am not sure how to do that?
-
@akrogolf which Duet board are you using?
-
@akrogolf What was the actual ambient temperature at the time? The bed is showing almost 36, so I assume that was not it?
-
@gloomyandy
about 25C. Bed was cooling. Sorry - i claimed that bed was accurate. -
The newest duet 3 mini wifi. I think .02 version?
-
