BLTouch and : Pin 'zprobe.in' is not free
-
@JADoglio do you have deployprobe.g and retractprobe.g in your sys folder?
-
@jay_s_uk Good question. Yes and I should have included that. And using M98 they both work as expected. Thanks
-
@JADoglio what M98 are you using to call them?
-
@jay_s_uk M98 P"deployprobe.g" M98 P"retractprobe.g"
-
@JADoglio said in BLTouch and : Pin 'zprobe.in' is not free:
M574 Z1 S1 P"^zprobe.in"
oh, remove this line from your config.g
-
@JADoglio that should allow M401 and M402 to work then as they appear to be in the correct place
-
@jay_s_uk If I remove that what will define my Z endstop?
-
@JADoglio you can't define a pin more than once for anything. you don't need any M574 line for Z to use a probe. none of my printers have a z endstop defined
-
@jay_s_uk OK thanks. I didn't realize that. I will give it a try. I am doing a PID Autotune on the bed right now as I just replaced that as well. Once it is done I will try your suggestion.
-
@JADoglio Thanks You very much. I don't care how many hours I spend printing, building printers, and upgrading there is always something new to learn and thankfully someone out there to teach it.
-
undefined Phaedrux marked this topic as a question
-
undefined Phaedrux has marked this topic as solved
