Bed tuning

[tecno]

022-06-21 18:21:42	Auto tune starting phase 2, settling
2022-06-21 18:20:56	Auto tune starting phase 1, heating up
2022-06-21 18:20:51	M303 H0 P1 S60
Auto tuning heater 0 using target temperature 60.0°C and PWM 1.00 - do not leave printer unattended

Is this nomal that phase 2 takes so long? Now over 50 minutes and still in phase 2

Hardened Glass bed 10mm thick and 600mm in diameter.

[tecno]

Still in phase 2

[jay_s_uk]

@tecno welcome to the world of the new algorithm. Go grab a beer. It'll take a while yet

[tecno]

@jay_s_uk

I have to disappoint you, did not see that the fuse for the heater circuit blew. And now I also know why

Oil dropping from rail onto power inlet with built in fuse holder = not so good

[tecno]

@jay_s_uk

I see now what you wrote about new algoritm, phase 3 is a pain to wait out
Now tuning hotend

[RichardMacy]

Thanks for letting me know as well.

[RichardMacy]

This post is deleted!