Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    ADVREF pin location on Duex 5 Expansion board

    Duet Hardware and wiring
    2
    3
    98
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • code7undefined
      code7
      last edited by

      I'm adding a Duex 5 Expansion board to my Duet 2 wifi controller setup and moving over the thermistors (3 through 7) to the expansion board. I have a setup similar to the one linked below by @Sphyloid. Can someone tell me where I need to move the wire that I currently have connected to the ADVREF pin on the Duet 2 to on the Duex 5 Expansion Board?

      https://forum.duet3d.com/topic/22581/duet-wifi-2-exp-thermistor-usage?loggedin=true

      Delta Printer Using a Duet 2 Wifi v1.04c, FW3.4.0beta2, Duet WiFi sever 1.26, Duet Web Control 3.3.0

      alankilianundefined 1 Reply Last reply Reply Quote 0
      • alankilianundefined
        alankilian @code7
        last edited by alankilian

        @code7

        Can't you just connect the thermister to the Duex-5 connector?

        According to the schematic, the Duex5 has the 4.7K pullups already connected to ADVREF.
        Capture.PNG

        SeemeCNC Rostock Max V3 converted to V3.2 with a Duet2 Ethernet Firmware 3.2 and SE300

        code7undefined 1 Reply Last reply Reply Quote 1
        • code7undefined
          code7 @alankilian
          last edited by

          @alankilian

          Perfect - Thanks

          Delta Printer Using a Duet 2 Wifi v1.04c, FW3.4.0beta2, Duet WiFi sever 1.26, Duet Web Control 3.3.0

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA