Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Curious motor issue.

    Scheduled Pinned Locked Moved
    Using Duet Controllers
    2
    2
    120
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • breedundefined
      breed
      last edited by

      The other night I grabbed a pancake stepper out of my stepper drawer for an extruder on a printer I'm building. Whenever I try and move it it just sits and vibrates. Ohmed out the cable/motor at the board end connector and it ohmed good. Tried my troubleshooting cable anyhow and it still just vibrated. Tried moving it to a different driver, the same. Grabbed a different stepper out of the drawer and it ran fine on both drivers. Grabbed my Megger and Megged out the pancake. Checked coil ohms compared to other steppers in drawer. Everything seems ok. I don't need the motor as I have plenty just a curious mystery. Any ideas?

      jumpedwithbothfeetundefined 1 Reply Last reply Reply Quote 0
      • jumpedwithbothfeetundefined
        jumpedwithbothfeet @breed
        last edited by

        @breed have you checked the phases are connected correctly some steppers need the middle two wires crossed over?

        6HC Voron Trident based, 6XD CNC, Mini 5 polar printer

        1 Reply Last reply Reply Quote 1
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA