Piezo Z-Probe inverted
-
Hi,
i just installed a piezo probe for my z-probe but i don't quite get it to do what i want.
The probe is working but reversed. untriggered it is at 1000 and when triggered goes down / to zero.So in essence it should be fine but i do not understand how to tell the board to just take the 1000 as standard and accept a lower signal as trigger. Also invertion with the I1 or I0 doesn't change it. Changing polarity on the piezo did not change it either.
Anyone got any idea where i am going wrong?
Z-Probe M558 P3 C"^zprobe.in" I0 R0.4 F300 X0 Y0 Z0 ; Set Z probe type to switch and the dive height + speeds G31 X0 Y0 Z-0.1 P600 ; Set Z probe trigger value, offset and trigger height_text
as said i tried P1, P3, I0, I1,
changed polarization. Anything i forgot? -
-
@siam thanks, that did it. Now i only need to find a spot where it triggers good enough for the bed but not while moving