e3d v6 config.g values needed

[Sardi]

Hi all.

I have an Ormerod 2 printer and will be switching the standard Ormerod hot end for the E3D V6.
The only M305 command I have in my config.g for the hot end is this

M305 P1 R4700 ; Set the hot end thermistor series resistor to 4K7

Im aware I need to add a B parameter at least, but what value should I set?
And are there any other parameters besides the B that I should add?

[alankilian]

@sardi

I don't use an E3D V6 hotend, but THIS page talks about the thermistor values.

I hope that helps.

[Sardi]

@alankilian it indeed does, my problem is solved. Thank you

[alankilian]

@sardi YEAH!