InputShaping-Plugin-0.2.0-pre3 released

GeneRisi

I am running a toolchanger and the printer is homed without a tool attached. A tool is then mounted and then I want to determine what input shaping should be used for that specific tool.

Does this mean I can't use the plugin because I can't home the printer with a tool attached (it will crash into the bed) ?

jay_s_uk

@generisi that is correct. You'll need to wait for an updated version

Heartleander81

@jay_s_uk I doun't become a error. He make a home and that was it.

Sotidii

@jay_s_uk said in InputShaping-Plugin-0.2.0-pre3 released:

M955 P0

P121.0 and P124.0

Heartleander81

My tool board is changed to 20

When I make the test with

G1 X100 F3000
G4 S2
M956 P20.0 S1000 A1
G1 X150 F6000

Work it fine. But with the plugin doun't make not more as a home

Heartleander81

@jay_s_uk I have Look to the link from you. I dount have the dsf-config.g is that the problem?

Sotidii

Duet3(DSF) toolboard 1.1 P121.0 does not work
Duet5 sammy P124.0 does not work

only homing ((

mfs12

Hey,

the process at the moment looks like:

home all axis (which i learned shouldn't be done especially for delta printers and devices with tool changers, going to remove this)
configure the input shaping algorithm
run test command (movement and acceleration data collection)
download acceleration data
process collected data
delete acceleration data on the device

If any of the steps fails, the process is aborted.

The printers which are bad configured after homing. I would be very interested in the precondition as part of a test. Rather them homing you want to configure a tool and a position. Is there anythings?

Found bugs:

parameter checking for algorithm configuration
using accelerometer on a toolboard (i.e. P121.0)

remove homing
clarify toolboard problem
improve parameter checking

Heartleander81

@mfs12 Which data would help? Unfortunately, I am not familiar with programming. With guidance, I could provide you with data from my system

mfs12

@Heartleander81 thanks. I probably understood the bug. The plugin is accessing the wrong status variables to determine success of recording. There will be a fix soon.

mfs12

Hey, a new version with a couple of bug fixes and small improvements got released.

Still experimental but i hope more usable. Especially i hope now can boards are properly supported.

https://forum.duet3d.com/topic/25349/inputshaping-plugin-0-2-0-pre4-released