TempTower Temp - PrusaSlicer
-
Hello Boys,
when i print a TempTower i add in prusaslicer the following Gcode:
M104 S255 in order to change my Printtemperature at a layer.
It's not looking like the print will wait for the Temp to be reached, can you confirm this?
Is there a M command to let the print wait for the targettemp? like M109 (for bed temp)?
After looking in the G Code Dictionary, i am not sure if M192: Wait for Probe Temperature maybe is this command? But im not sure what is meant with probe.Edit: The reason i ask is, that i use a copper hotend, and i have the feeling that the temp is falling pretty slow.
-
@d0minik96 https://duet3d.dozuki.com/Wiki/Gcode#Section_M109_Set_Extruder_Temperature_and_Wait
Or, use G10 S### and M116.
-
@d0minik96 said in TempTower Temp - PrusaSlicer:
Edit: The reason i ask is, that i use a copper hotend, and i have the feeling that the temp is falling pretty slow.
Are you beginning with the lowest temp?
When printing I temp tower I usually start with the lowest temp and increase the temp at a set layer. So I don't have to worry about falling temps. -
@argo
i print from highest to lowest. Ty for the commands
