Strange error with magnetic filament sensor
-
Good morning, I've just started a new print, and during the print of the first layer appeared the attached error message and the print went in pause...the layer wasn't particularry complicated, yes, there were a lot of retractions but is this a problem?
Is this error normal? (i don't hope so)
p.s.
I've been abel to resume the print and for now it looks all ok -
@the_dragonlord
what filament sensor are you using?
-
@Veti said in Strange error with magnetic filament sensor:
@the_dragonlord
what filament sensor are you using?
the original magnetic sensor
-
@the_dragonlord
the problem is with your sensor
post output M591 D0.
-
@Veti said in Strange error with magnetic filament sensor:
M591 D0
M591 D0
Duet3D rotating magnet filament monitor v3 on pin e0stop, enabled, sensitivity 25.80mm/rev, allow 70% to 130%, check every 3.0mm, version 3, mag 132 agc 102, measured sensitivity 25.64mm/rev, min 99% max 102% over 55.1mmand this is my setting:
M591 D0 P3 C"e0_stop" S1 R70:130 L25.8 E3.0 ;
-
@the_dragonlord
i think you need to calibrate the sensor again.
-
@Veti said in Strange error with magnetic filament sensor:
@the_dragonlord
i think you need to calibrate the sensor again.
ok, thanks
