Problem with PanelDue 5i
-
Having a weird issue with the newly installed Paneldue 5i on my Duet 3 6HC.
It boots up, i can control some of the duet features but it is stuck at connecting in the top right corner.
I have updated it to 1.24, and the Duet to 3.1.1 latest.
I checked that versions are indeed the ones flashed and they are.
I can home the duet, move axis, I can control hot end, bed, but i get no feedback whatsoever. Like the connection is 1 way.
I did add the:
M575 P1 B57600 S1
That didn't help.
Then I saw on the forum about adding it double as such:
M575 P1 B115200 S1 ; Set auxiliary serial port baud rate and require checksum (for PanelDue) M575 P1 B115200 S1 ; Set auxiliary serial port baud rate and require checksum (for PanelDue)Still no luck..
Anyone?
-
Once is enough, twice was a workaround a while back.
The simplest solution is that you've not connected the io0.out(?) pin to the PanelDue Rx pin properly?
-
Possible, but doubtful unless a wire is broken. Checking now.
-
Well, sure enough, the green wire was not making connection in the crimp (from factory).
Recrimped, works!
