Hotend modes "off", "standby", "active"
-
@Plohish Please update your firmware to 3.1.1 and the Panel to 1.24 and see if that still holds true.
-
@Phaedrux my panel has firmware 1.24
Today I’m not ready to upgrade the Duet to 3.1.1, maybe I will do it later -
@Plohish Its a much easier upgrade than going from 2x to 3x.
-
the ATX OFF button from the web interface turns off the printer even if the hot end has a temperature above 45 degrees, is this normal?
-
@Phaedrux I changed the firmware to 3.1.1
this did not help me solve the problem incorrect display of temperature on the panel -
Yes it’s normal if you just send M81
Use S1 parametersM81 ; turn power off immediately
M81 S1 ; turn power off when all thermostatic fans have turned off -
@OwenD I thought the duet button is much more intelligent and understands that turning off is not desirable
I know about M81 S1 doing it from a macro -
@Plohish said in Hotend modes "off", "standby", "active":
@OwenD I thought the duet button is much more intelligent and understands that turning off is not desirable
I know about M81 S1 doing it from a macroPerhaps @chrishamm can make that configurable?
-
@Phaedrux What do you think about the problem of displaying temperature on the panel?
-
@Plohish I'm not sure about that part either.
