Can't connect via wifi

SpeedyDad

While mid print, my wifi connection to the Duet disconnected. I was unable to reconnect even after turning off and starting the wifi module via the PanelDue. When I start the machine, the blue wifi LED blinks very briefly then goes out.

I reinstalled the firmware for the DuetWifi itself, Wifi server, and web control. I've reset the Wifi with M552 S-1.
When I connect via the Machine control in Simplify 3D, I get:
"Wifi reported error: no known networks found"
"Wfif module is idle"
When I issue M587 S"" P"" (with my info), I get:
"M587: Failed to add SSID to remembered list"
Followed shortly by:
"Error Retrieving WIFI status message: Bad reply format Version"

If I run a M588 with my network info, I get:
"M588: Failed to remember SSID to remembered list"

I'm running Firmware 2.05.1

Dead Duck? Thoughts?

try

M552 S-1
M552 S0 
G4 S1 
M588 S"*"; forget all previous access point info
M587 S"" P""

SpeedyDad

Yup, that got it. I had done all of that before in that order minus the G4 line. What did that do?

it just waits a second, not strictly needed if you're typing the commands, but is needed if you copy/paste to a terminal

SpeedyDad

Thanks. All is good now.