Macro doesnt work!
-
Hello together!
I am new here and this is also my first hevo which i am building and my first duet 2 wifi board ever...
so please be forgiving if I do something wrong or something is my mistake
I create a Macro called "Motoren deaktivieren" and in this Macro i put the M84 command!
After Saving and exeuting the macro i can move to axis, so this was successfully!BUT, if i write comments in the macro like this:
M84 #Motoren deaktivierenand save & execute this again, nothing will be happen.
No error or other, but i also can NOT move the Axis?what is wrong here?
I am Using a DUet 2 Wifi with the lates 2.x Firmware and the latest Webfirmware from Github!
Thanks & Kind Regards
-
@xenon2008 said in Macro doesnt work!:
M84 #Motoren deaktivieren
you have to use a semicolon for the commend try M84 ;Motoren deaktivieren
-
ohhhh! thanks, i will try it as soon as the current printing is finished. my first xy calibration cube * I'm proud *
do I need a semicolon for all commands?
-
the semicolon is used to indicate that whatever follows, until the end of the line, is a comment
-
okay thank you very much for the quick and friendly answer
