Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    extruder 0 reports no filament

    Scheduled Pinned Locked Moved
    General Discussion
    2
    2
    261
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • TLeTourneauundefined
      TLeTourneau
      last edited by

      What can cause an "extruder 0 reports no filament" message and the printing to pause? The printer has a standard switch type filament sensor and isn't running out of filament. If I press resume the print resumes without issue.

      Thanks,
      Tom

      TronXY X5S-500 (CoerXY)
      Duet 2 Ethernet v1.04
      Firmware Version: 2.02(RTOS) (2018-12-24b1)
      Web Interface Version: 1.22.6
      7" PanelDue
      E3D V6 Clone
      MOSFET's for hot end
      1000w Keenovo with SSR for heat bed
      dc42 Mini IR Sensor or BLTouch

      1 Reply Last reply Reply Quote 0
      • jens55undefined
        jens55
        last edited by

        Intermittent switch or wiring ? I have experienced that before where there was an intermittent and very short interruption in the signal. The printer sees it and by the time you get to it the signal is back to normal.

        1 Reply Last reply Reply Quote 1
        • First post
          Last post
        Unless otherwise noted, all forum content is licensed under CC-BY-SA