When is M291 going to be fixed?

[chas2706]

I have a macro to level the bed screws and at some point it uses this command to jog the Z axis:

M291 P"Carefully Jog the Z Axis until paper grips nozzle and click OK" R"Setting Z=0" Z1 S3

Can't remember if it is DWC or DSF issue.
Anyway we just get "command not supported" error.

I can no longer use this and many more macro's that contain M291 commands.
When is this going to be fixed?

[SIam]

in rrf 3.0 and dwc 2.0.7 is it working

[chas2706]

@SIam Not if you have Duet3 with SBC!