Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Simple Filament Sensor, "no filament" after update 2.03 > 2.05

    Scheduled Pinned Locked Moved
    Filament Monitor
    1
    1
    90
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • brasseundefined
      brasse
      last edited by

      Hello.

      My setup is not working after updating firmware from 2.03 to 2.05.

      I have my sensor set up like this:
      M591 D0 P1 C3 S1

      When i start a print, i get a popup message saying:
      "Extruder 0 reports no filament", and the print stops directly. It does not start if i press "Resume"

      "M591 D0" reports that i have filament in:
      Simple filament sensor on endstop 3, enabled, output low when no filament, filament present: yes

      What should i do to fix this?

      Best Regards

      1 Reply Last reply Reply Quote 0
      • First post
        Last post
      Unless otherwise noted, all forum content is licensed under CC-BY-SA